HP-UX IPv6 Transport Administrator's Guide for TOUR 1.0

Installation
Installing HP-UX 11i IPv6 (bundled as part of TOUR 1.0)
Chapter 2 9
Installing HP-UX 11i IPv6 (bundled as part of
TOUR 1.0)
HP-UX 11i IPv6 is a component of TOUR 1.0. The complete TOUR 1.0
product bundle must be installed. You can download the TOUR 1.0 depot
from www.software.hp.com (Keyword “TOUR”).
You can follow the Installation instructions provided on the web. These
steps are also summarized below. For additional information, refer to the
TOUR 1.0 Release Notes.
System Requirements
TOUR 1.0 must be installed on an HP-UX 11i system. You can install it
on a 32-bit or 64-bit environment. It requires approximately 8-9 Mbytes
of free disk space. (~7 Mbytes is used in /usr, ~1 Mbyte is used in /var.)
The approximate file size of the TOUR 1.0 depot file is less than 4.5
Mbytes. (Note that this disk space information does not include disk
space requirements for prerequisite patches.)
Installation Instructions
To install TOUR 1.0 on HP-UX 11i, complete the following steps:
1. Install the following patches:
NOTE A few patches are kernel patches. Therefore, these patches require a
system reboot.
• Install the latest (March 2003 - B.11.11.0212.4 or later) HP-UX
11i Quality Pack (GOLDQPK11i) patch bundle.
• In addition, you must install the following patches (or later):
— PHCO_24287 - “patch for the syslogd(1M) command”
— PHNE_28476 - “cumulative STREAMS patch”
— PHNE_27796 - “libnss_dns DNS backend patch”