HP-UX IPv6 Transport Administrator Guide HP-UX 11i v3 (5992-6426, May 2013)
Table Of Contents
- HP-UX IPv6 Transport Administrator Guide
- Contents
- About This Document
- 1 Features Overview
- IPv6 Transport
- New IPv6 Transport Features
- Support for RFC 3542 (Advanced Sockets API for IPv6)
- Configurable Policy Table Support
- Anycast Address Support
- Support for RFC 4291 (IP Version 6 Addressing Architecture)
- Support for RFC 4213 (Basic Transition Mechanisms for IPv6 Hosts and Routers)
- Support for RFC 3484 (Default Address Selection for Internet Protocol version 6 (IPv6))
- Support for RFC 3493 (Basic Socket Interface Extensions for IPv6)
- Support for RFC 4584 (Extension to Sockets API for Mobile IPv6)
- Support for RFC 4193 (Unique Local IPv6 Unicast Addresses)
- Support for RFC 4443 (Internet Control Message Protocol for IPv6 (ICMPv6))
- Support for IPv6 over VLAN
- Ability to Disable Autoconfiguration Based on Router Advertisements
- Support for RFC 3810 (Multicast Listener Discovery Version 2 (MLDv2))
- Support for RFC 3376 (Internet Group Management Protocol Version 3 (IGMPv3))
- Support for RFC 3678 (Socket Extension to Multicast Source Filter API)
- Support for RFC 4941 (Privacy Extensions for Stateless Address Autoconfiguration in IPv6)
- New ndd Tunables
- IPv6 Transport Features Available in the Core HP-UX 11i v3 Operating System
- Limitations
- IPv6 Transport
- 2 Configuration
- Configuring IPv6 Interfaces and Addresses
- Stateless Autoconfiguration
- Manual Configuration
- Configurable Policy Table for Default Address Selection for IPv6
- Host Names and IPv6 Addresses
- 3 Troubleshooting
- 4 IPv6 Addressing and Concepts
- 5 IPv6 Software and Interface Technology
- 6 Utilities
- A IPv6 ndd Tunable Parameters
- Index
Table 6 Supported IPv6 ndd parameters (continued)
DescriptionParameter
Enables the RFC 4291 functionality.ip6_enable_rfc4291
Controls the MLD protocol version used by the system.ip6_mld_version
Enables or disables RFC 3484.ip6_addr_sel_enable
Specifies whether to report additional ICMPv6 error messages
as defined in RFC 4443.
ip6_icmp6_extended_errors
Controls the IGMP protocol version used by the system.ip_igmp_version
Controls the generation of IPv6 temporary addresses as defined
in RFC 4941.
ip6_nd_use_temp_address
Controls the upper limit of valid lifetime for IPv6 temporary
addresses configured using router advertisements.
ip6_nd_temp_valid_lifetime
Controls the upper limit of preferred lifetime for IPv6 temporary
addresses configured using router advertisements.
ip6_nd_temp_preferred_lifetime
Controls the source address selection preference to use an
IPv6 temporary address instead of a public IPv6 address.
ip6_nd_prefer_temp_address
Controls IPv6 auto-configuration from the router advertisement.ip6_nd_autoconf
Controls compatibility with the old version of MLD.ip6_mld_compat_disable
Specifies the MLD robustness variable.ip6_mld_rv
Specifies the maximum source addresses in the MLDv2 filter.ip6_mld_maxsrc
Specifies the MLDv2 unsolicited report interval.ip6_mld_v2_unsolicited_interval
Specifies the MLD query response interval.ip6_mld_qri
Displays a report of the MLD state.ip6_mld_status
Controls compatibility with old version of IGMP.ip_igmp_compat_disable
Specifies the IGMP robustness variable.ip_igmp_rv
Specifies the maximum source addresses in the IGMPv3 filter.ip_igmp_maxsrc
Specifies the IGMPv3 unsolicited report interval.ip_igmp_v3_unsolicited_interval
Specifies the IGMP query response interval.ip_igmp_qri
Displays a report of the IGMP state.ip_igmp_status
Specifies the maximum source addresses in the application
filter.
ip_ipc_mcast_maxsrc
Disables sending of ICMPv6 destination unreachable message.ip6_ill_no_dest_unreach
IPV6 Neighbor Discovery (ND)
68 IPv6 ndd Tunable Parameters