HP-UX IPv6 Transport Administrator Guide HP-UX 11i v3 (5992-6426, May 2013)

On Host A:
— Using ifconfig (ephemeral), enter:
ifconfig iptu0 inet6 tunnel ip6inip fe80::1 fe80::2 tsrc 192.168.1.1 tdst 10.13.2.2 up
— Editing /etc/rc.config.d/netconf-ipv6 (permanent), add:
TUN_INTERFACE_NAME[0]=”iptu0”
TUN_TYPE[0]=”ip6inip”
TUN_LOCAL_ADDRESS[0]=”fe80::1”
TUN_REMOTE_ADDRESS[0]=”fe80::2”
TUN_ENCAP_SRC_ADDRESS[0]=”192.168.1.1”
TUN_ENCAP_DST_ADDRESS[0]=”10.13.2.2”
TUN_INTERFACE_STATE[0]=”up”
On Host B:
— Using ifconfig (ephemeral), enter:
ifconfig iptu0 inet6 tunnel ip6inip fe80::2 fe80::1 tsrc 10.13.2.2 tdst 192.168.1.1 up
— Editing /etc/rc.config.d/netconf-ipv6 (permanent), add:
TUN_INTERFACE_NAME[0]=”iptu0”
TUN_TYPE[0]=”ip6inip”
TUN_LOCAL_ADDRESS[0]=”fe80::2”
TUN_REMOTE_ADDRESS[0]=”fe80::1”
TUN_ENCAP_SRC_ADDRESS[0]=”10.13.2.2”
TUN_ENCAP_DST_ADDRESS[0]=”192.168.1.1”
TUN_INTERFACE_STATE[0]=”up”
Configured IP6-in-IP6 Tunnel (Host-Host) Example
This section provides an example of how to configure a host-host IP6-in-IP6 configured
tunnel . IP6-in-IP6 tunnel configuration allows transmission of IPv6 packets encapsulated
in an IPv6 header.
On Local Host:
— Using ifconfig (ephemeral), enter:
ifconfig ip6tu0 inet6 tunnel ip6inip6 fe80::1 fe80::2 tsrc 2001:db8:2::1 tdst 2001:db8:3::1 up
— Editing /etc/rc.config.d/netconf-ipv6 (permanent), add:
TUN_INTERFACE_NAME[0]=”ip6tu0”
TUN_TYPE[0]=”ip6inip6”
TUN_LOCAL_ADDRESS[0]=”fe80::1”
TUN_REMOTE_ADDRESS[0]=”fe80::2”
TUN_ENCAP_SRC_ADDRESS[0]=”2001:db8:2::1”
TUN_ENCAP_DST_ADDRESS[0]=”2001:db8:3::1”
TUN_INTERFACE_STATE[0]=”up”
Migrating from IPv4 to IPv6 57