HP-UX IPv6 Transport Administrator Guide HP-UX 11i v3 (5992-6426, May 2013)

Table Of Contents

Stateless Autoconfiguration......................................................................................23

Configuring a Primary Interface (Required)............................................................24

Configuring Secondary Interfaces........................................................................24

Configuring Route Information.............................................................................24

Manual Configuration.............................................................................................25

Configuring a Primary Interface...........................................................................25

Configuring Secondary Interfaces........................................................................25

Configuring a Default IPv6 Route.........................................................................26

Configuring Anycast Addresses............................................................................26

Tunneling .........................................................................................................26

Creating an IP6-in-IP Point-to-Point Configured Tunnel.........................................27

Creating a “6to4” Point-to-Multipoint Configured Tunnel.....................................27

Enabling rtradvd (Router Advertiser Daemon)........................................................28

Activating netconf-ipv6 file Configuration..............................................................29

Example ifconfig and route Commands................................................................29

To configure a primary interface, enter:............................................................29

To configure a secondary interface, enter:........................................................29

To configure a secondary interface with an anycast address, enter:.....................30

To add a default IPv6 route, enter: ..................................................................30

To create an IP6-in-IP tunnel, enter:..................................................................30

To create a “6to4” tunnel, enter:.....................................................................30

Configurable Policy Table for Default Address Selection for IPv6...................................30

Configuring Policies Using the ip6addrpol.conf File................................................30

Activating the ip6addrpol.conf File.......................................................................31

Configuring Policies Using the ip6addrpol Command.............................................31

Host Names and IPv6 Addresses..............................................................................31

Creating the /etc/hosts File................................................................................31

Example Host Name Entry.............................................................................32

Name and Address Lookup for IPv6.....................................................................32

Manually editing nsswitch.conf.......................................................................33

3 Troubleshooting.....................................................................................................................34

Troubleshooting Overview.......................................................................................34

Diagnostic Flowcharts.............................................................................................34

Flowchart 1: Transport Level Testing using Internet Services......................................35

Flowchart 1 Procedures..................................................................................35

Flowchart 2: Network Connectivity Test.................................................................36

Flowchart 2 Procedures..................................................................................37

Flowchart 3: Name Service Test...........................................................................38

Flowchart 3 Procedures..................................................................................38

Flowchart 4: Interface Test...................................................................................40

Flowchart 4 Procedures..................................................................................40

Flowchart 5: Interface Test continued....................................................................42

Flowchart 5 Procedures..................................................................................42

Flowchart 6: Router Remote Loopback Test............................................................44

4 Contents