HP-UX IPSec Version A.03.00 Administrator's Guide

Step 4: Completing Post-Installation Migration Requirements
If you are migrating from a previous version of HP-UX IPSec, run the ipsec_migrate utility
and complete other post-installation migration procedures, as described in Appendix C,
“Post-Installation Migration Instructions” (page 201).
Removing HP-UX IPSec
Use the following procedure to remove HP-UX IPSec:
1. Stop HP-UX IPSec by entering the following command:
# ipsec_admin -stop
2. Use the swremove utility to remove the IPSec software bundle.
3. Remove the directory /var/adm/ipsec.
4. If you are using certificate-based authentication, revoke your certificate.
52 Installing HP-UX IPSec