HP-UX IPSec Version A.03.00 Administrator's Guide

Step 1: Verifying HP-UX IPSec Installation and Configuration Prerequisites
1. Verify that the operating system version is HP-UX 11i version 3 (B.11.31) or HP-UX 11i v2
Update 2 (v2UD2).
To determine the OS version, enter the following command:
uname -a
2. Verify that you have the required OpenSSL version installed on your system, as listed in
“Software Requirements” (page 48). Enter the following command:
# what /usr/bin/openssl
3. Check the latest HP-UX IPSec documentation set for release notes that might contain updated
or additional software dependencies..
To determine the patches installed on the system, enter the following command:
swlist -i
4. If you are migrating from a previous version of HP-UX IPSec, be sure you have completed
the procedures in Appendix C, “Pre-Installation Migration Instructions” (page 201).
Step 1: Verifying HP-UX IPSec Installation and Configuration Prerequisites 49