HP-UX IPSec version A.02.01 Administrator's Guide

HP-UX IPSec Configuration Examples
Appendix D258
This appendix provides configuration examples for the following
topologies:
• “Host to Host telnet” on page 259
This section contains example ipsec_config batch files for
encrypting and authenticating all telnet traffic between two systems
using dynamic keys and preshared keys for IKE authentication.
• “Subnet ESP with Exceptions” on page 263
This section contains an example ipsec_config batch file for an
HP-UX IPSec closed secure network that communicates with one
system outside the network (Potato). All packets to and from system
Potato are secured, and all packets within the local network are
secured, except for ICMP packets, which pass in clear text.
• “Host to Gateway” on page 266
This section contains an example ipsec_config batch file for an end
system using an IPsec tunnel to a gateway.
• “Autoconfiguration Clients” on page 268
This section contains an example ipsec_config batch file for use
with autoconfiguration clients (clients with dynamically assigned IP
addresses, such as IPv6 stateless autoconfiguration clients, and
DHCP and DHCPv6 clients).
• “Manual Keys” on page 271
This section contains example ipsec_config batch files for
encrypting and authenticating rlogin from one system to a second
system between using manual keys.
Configuration examples for Mobile IPv6 are provided in Appendix F,
“Mobile IPv6 Manual Key Configuration Example” on page 315 and
“Mobile IPv6 Dynamic Key Configuration Example” on page 319.
NOTE The addresses and keys in these examples are for illustrative purposes
only.