HP-UX IPSec version A.02.01 Administrator's Guide

Configuring HP-UX IPSec
Step 8: Committing the Batch File Configuration and Verifying Operation
Chapter 4 147
bytes processed: 6256
addtime (seconds): 3
usetime (seconds): 30
--- Hard Lifetimes ---
bytes processed: 0
addtime (seconds): 28800
usetime (seconds): 28800
The information for the inbound IPsec SA corresponds to inbound
traffic from the remote system (the source address is 15.2.2.2).
----------- IPsec SA ------------------------
Sequence number: 2
SPI (hex): 13BDB7 State: MATURE
SA Type: ESP with AES128-CBC encryption and HMAC-SHA1
authentication
Src IP Addr: 15.2.2.2 Dst IP Addr: 15.1.1.1
--- Current Lifetimes ---
bytes processed: 6344
addtime (seconds): 31
usetime (seconds): 30
--- Hard Lifetimes ---
bytes processed: 0
addtime (seconds): 28800
usetime (seconds): 28800
For more information on the ipsec_report command, refer to
the ipsec_report (1M) manpage.
7. Verify any entries in the bypass list.
Enter the following command:
ipsec_report -bypass
In addition, you can enter the following commands and verify that
none of the active host or gateway IPsec policies include addresses in
the bypass list:
ipsec_report -host
ipsec_report -gateway
Go on to “Step 9: Configuring HP-UX IPSec to Start Automatically” on
page 148.