HP-UX IPSec version A.02.00 Administrator's Guide

Configuring HP-UX IPSec
Step 1: Configuring Host IPSec Policies
Chapter 3 73
-protocol
protocol_id
The protocol_id is the value or name of the upper-layer protocol that
HP-UX IPSec uses in the address filter to select an IPSec policy for a
packet. You cannot specify protocol and a
service_name in the same
policy.
Specifying ICMPV6 affects only the following ICMPv6 messages: Echo
Request, Echo Reply, Mobile Prefix Solicitation, Mobile Prefix
Advertisement.
To ensure proper operation of IPv6 networks, HP-UX IPSec always
allows all ICMPv6 messages not listed above to pass in clear text
Acceptable Values: Integer value 0 (any protocol) - 255, or one of the
following protocol names:
TCP
UDP
FTP-CONTROL 21 TCP
HTTP-TCP 80 TCP
HTTP-UDP 80 UDP
NTP 123 UDP
REXEC 512 TCP
RLOGIN 513 TCP
RWHO 513 UDP
REMSH 514 TCP
REMPRINT 515 TCP
SMTP 25 TCP
TELNET 23 TCP
TFTP 69 UDP
Table 3-1 ipsec_config Service Names (Continued)
Service
Name
Port Protocol