HP-UX IPSec version A.02.00 Administrator's Guide

Configuring HP-UX IPSec
Configuration Overview
Chapter 368
Step 5. Configure security certificates and IKE ID information, if you are using
RSA signatures for IKE authentication.
See Chapter 4, “Using Certificates with HP-UX IPSec,” on page 113 for a
description of this step.
Step 6. Configure the bypass list of local IPv4 addresses (optional).
See “Step 6: Configuring the Bypass List (Local IPv4 Addresses)” on
page 101 for a description of this step.
Step 7. Verify the batch file.
HP recommends that you use an ipec_config batch file to add
configuration information, and that you use the ipsec_config batch
command with the nocommit option to verify the contents of the batch
file before committing the batch file operations to the database file. See
“Step 7: Verify Batch File Syntax” on page 104 for a description of this
step.
Step 8. Commit the batch file operations to the database and start HP-UX IPSec
to verify operation.
After you have verified the contents of the batch file, commit the batch
file operations to the configuration database file. Start HP-UX IPSec and
verify operation. See “Step 8: Committing the Batch File Configuration
and Verifying Operation” on page 105 for a description of this step.
Step 9. Configure HP-UX IPSec to start automatically at system boot-up time
(optional).
See “Step 9: Configuring HP-UX IPSec to Start Automatically” on
page 109 for a description of this step.
Step 10. Back up the ipsec_config batch file and the configuration database.
See “Step 10: Creating Backup Copies of the Batch File and
Configuration Database” on page 111 for a description of this step.