HP-UX IPSec version A.02.00 Administrator's Guide

Troubleshooting HP-UX IPSec
Troubleshooting Scenarios
Chapter 5 185
Autoboot is Not Working Properly
Problem
Autoboot fails.
Symptoms
HP-UX IPSec does not start automatically at system boot-up time.
Solution
Use the following procedure:
Step 1. Set the HP-UX IPSec password using the ipsec_admin -newpasswd
command if it is not already set.
Step 2. Use ipsec_config to configure HP-UX to start automatically at system
boot-up time:
ipsec_config add startup -autoboot ON
Step 3. Check that your configuration file is valid.
Step 4. Reboot the system.
If you still have problems after following the troubleshooting procedure,
contact your HP representative.
If HP-UX IPSec is not using the IPSec policy you expected, check for
errors in the configuration file, such is incorrect IP addresses. Check the
order of the IPSec policies—HP-UX IPSec sequentially searches the
IPSec policies and selects the first policy with filter parameters that
match the packet.
Administrator Cannot Get a Local VeriSign
Certificate
Problem
The administrator cannot get a local VeriSign certificate.