HP-UX IPFilter Version 17 Administrator's Guide

kctune -s fr_statemax=6000
3. Configure the module for the new value using the following commands:
cd /stand/ipf
config -M ipf -u
4. Reload the ipf module:
/sbin/init.d/ipfboot start
C.9 Enabling and Disabling NAT Functionality
The new ipnat_enable tunable is provided to enable/disable NAT functionality. By default,
this tunable is set to 1. If you do not use NAT functionality, disabling this tunable will improve
performance.
NOTE: This available only on 11i v3.
C.9 Enabling and Disabling NAT Functionality 147