Command Reference Guide

Administration Commands
status_dependent_lu
TRP1 TR Inactive My first por
TRL0 PU0 TR Inactive Link to host
TRP2 TR Active My second po
TRL1 AS400 TR Active Link to AS/4
TRL2 PUNAME TR Stopping Link to othe
ETH0 Eth Active Another DLC
ETHER0 Eth Active My Ethernet
ETH0 PU5 Eth On demand Link for app
DOWN PU6 Eth Inactive Downstream t
SDLC0 SDLC Active SDLC dev 1
SDLCP0 SDLC Inactive My first por
HOST PU0 SDLC Inactive Link to host
--------------------------------------------------------------------------------
2.199.3 Error Return Codes
If the command cannot be executed, SNAplus2 returns a primary return code to indicate the type of error and a
secondary return code to provide specific details about the reason for unsuccessful execution.
Parameter Check
No parameter errors occur for this command.
State Check
No specific state errors, other than those listed in Appendix A, Common Return Codes from snapadmin Commands,
occur for this command.
Other Conditions
Appendix A, Common Return Codes from snapadmin Commands, lists combinations of primary and secondary
return codes that are common to all commands.
2.200 status_dependent_lu
The status_dependent_lu command returns information about the status of all dependent LUs on the node.
2.200.1 Supplied Parameters
Parameter name Type Length Default
[status_dependent_lu]
pu_name character 8 (null string)
lu_type constant ALL
Supplied parameters are:
pu_name
Name of physical unit (PU) used by the dependent LU. When you specify this parameter, status is returned
for all dependent LUs that are associated with this PU.
lu_type
Specifies the type of LUs for which status is to be returned. Possible values are:
ALL
609