Command Reference Guide

Administration Commands
set_bck_cs_trace
Specifies whether to initialize tracing (define the tracing state at all interfaces) or to change the state of tracing
at one or more interfaces (leaving the others unchanged). Possible values are:
YES
Initialize tracing. The trace_flags parameter defines the required state of tracing at all interfaces.
NO
Change the state of tracing. The trace_flags parameter defines the interfaces where tracing is to be
activated or deactivated; other interfaces will not be affected.
set_flags
If init_flags is set to NO, this parameter specifies whether tracing is to be activated or deactivated at the
requested interfaces. Possible values are:
YES
Activate tracing at the interfaces specified by the trace_flags parameter.
NO
Deactivate tracing at the interfaces specified by the trace_flags parameter.
If init_flags is set to YES, this parameter is ignored.
2.183.2 Returned Parameters
No parameters are returned by SNAplus2 when this command executes successfully.
2.183.3 Error Return Codes
If the command cannot be executed, SNAplus2 returns a primary return code to indicate the type of error and a
secondary return code to provide specific details about the reason for unsuccessful execution.
Parameter Check
No parameter errors occur for this command.
State Check
If the command does not execute because of a state error, SNAplus2 returns the following parameters:
primary_rc
STATE_CHECK
secondary_rc
INVALID_TARGET
The back-level support software is not running on the target server.
Other Conditions
Appendix A, Common Return Codes from snapadmin Commands, lists combinations of primary and secondary
return codes that are common to all commands.
580