Command Reference Guide

Administration Commands
reset_session_limit
YES
Reset the maximum negotiable session limit for this LU-LU-mode combination to 0 (so that sessions
cannot be activated until the limit is changed by initialize_session_limit).
NO
Leave the maximum negotiable session limit unchanged.
responsible
Indicates whether the source (local) or target (partner) LU is responsible for deactivating sessions after the
session limit is reset. Possible values are:
SOURCE
The local LU is responsible for deactivating sessions.
TARGET
The partner LU is responsible for deactivating sessions.
drain_source
Specifies whether the source LU satisfies waiting session requests before deactivating a session. Possible
values are:
YES
Waiting session requests are satisfied.
NO
Waiting session requests are not satisfied.
drain_target
Specifies whether the target LU satisfies waiting session requests before deactivating a session. Possible
values are:
YES
Waiting session requests are satisfied.
NO
Waiting session requests are not satisfied.
force
Specifies whether to set session limits to 0 even if CNOS negotiation fails. Possible values are:
YES
Set session limits to 0.
NO
Do not set session limits to 0 even if CNOS negotiation fails.
2.182.2 Returned Parameters
If the command executes successfully, SNAplus2 returns the following parameters:
primary_rc
OK
secondary_rc
576