Command Reference Guide

Administration Commands
query_statistics
last_fail_frmr_info
If the last LS failure was caused by an FRMR frame that was not valid, this parameter contains the information
from the FRMR frame. If the LS has not failed or if the failure was not caused by a frame that was not valid,
this parameter is set to zeros.
last_fail_replyto_s
The number of times that the reply timeout expired before the last failure. If the LS has not failed, this
parameter is set to
0.
g_poll
The group poll address for the LS. If the LS is not in a group, this parameter is set to
0.
sim_rim
Specifies whether the LS supports transmission of SIM and RIM control frames. Possible values are:
YES
LS supports SIM and RIM.
NO
LS does not support SIM and RIM.
xmit_rcv_cap
Specifies the transmit / receive capability of the LS. Possible values are:
HALF
Half-duplex
FULL
Full-duplex
2.170.4 Returned Parameters: SDLC Port Statistics
Parameter name Type
index decimal
dwarf_frames decimal
polls_out decimal
poll_rsps_out decimal
local_busies decimal
remote_busies decimal
iframes_in decimal
iframes_out decimal
octets_in decimal
octets_out decimal
protocol_errs decimal
activity_to_s decimal
rnrlimit_s decimal
retries_exps decimal
retransmits_in decimal
retransmits_out decimal
If the command executes successfully, the following parameters are returned:
index
The index value used internally by SNAplus2 to identify the port.
dwarf_frames
The number of frames received by the port that were too short to be valid.
545