Command Reference Guide

Administration Commands
query_pu
Name of the DLC associated with this port.
lsap
Enterprise Extender (HPR/IP): Link Service Access Point address of the port.
version
Enterprise Extender (HPR/IP): IP version for which this IP address is defined. This is set to
IP_VERSION_4.
determined_ip_address
Enterprise Extender (HPR/IP): IP address of the local link station. This is a dotted-decimal IP address (such
as
193.1.11.100). If the port is inactive, the address appears as 0.0.0.0.
For more information about the remaining parameters, see the define_*_port command for the appropriate port
type.
2.160.4 Error Return Codes
If the command cannot be executed, SNAplus2 returns a primary return code to indicate the type of error and a
secondary return code to provide specific details about the reason for unsuccessful execution.
Parameter Check
If the command does not execute because of a parameter error, SNAplus2 returns the following parameters:
primary_rc
PARAMETER_CHECK
secondary_rc
Possible values are:
INVALID_PORT_NAME
The list_options parameter was set to LIST_INCLUSIVE to list all entries starting from the supplied
name, but the value specified in the port_name parameter was not valid.
State Check
No specific state errors, other than those listed in Appendix A, Common Return Codes from snapadmin Commands,
occur for this command.
Other Conditions
Appendix A, Common Return Codes from snapadmin Commands, lists combinations of primary and secondary
return codes that are common to all commands.
2.161 query_pu
The query_pu command returns information about local PUs and the links associated with them. This command
can be used to obtain information about a specific PU or about multiple PUs, depending on the options used.
2.161.1 Supplied Parameters
Parameter name Type Length Default
[query_pu]
num_entries decimal 1
510