Command Reference Guide

Administration Commands
aping
The minimum time in milliseconds required for a data-sending iterationthe shortest measured time for a
single iteration of sending data and receiving either data or conrmation. If
iterations was set to 0 (zero),
this parameter is not used.
avg_time
The average time in milliseconds required for a data-sending iterationthe average time for a single iteration
of sending data and receiving either data or conrmation. If iterations was set to 0 (zero), this parameter is
not used.
max_time
The maximum time in milliseconds required for a data-sending iterationthe longest measured time for a
single iteration of sending data and receiving either data or conrmation. If iterations was set to 0 (zero),
this parameter is not used.
partner_ver_len
Actual length of the verication string returned by the partner TP.
partner_ver_data
Verication string returned by the partner TP. If partner_ver_len is 0 (zero), then this string is not returned.
2.4.3 Error Return Codes
If the command cannot be executed, SNAplus2 returns a primary return code to indicate the type of error and a
secondary return code to provide specic details about the reason for unsuccessful execution.
Parameter Check
If the command does not execute because of a parameter error, SNAplus2 returns the following parameters:
primary_rc
PARAMETER_CHECK
secondary_rc
Possible values are:
INVALID_LU_ALIAS
The lu_alias parameter value did not match any dened LU alias.
INVALID_LU_NAME
The lu_name parameter value did not match any dened LU name.
BAD_PARTNER_LU_ALIAS
The value specied for plu_alias did not match any dened partner LU.
State Check
No specic state errors, other than those listed in Appendix A, Common Return Codes from snapadmin Commands,
occur for this command.
Other Conditions
If the command does not execute because other conditions exist, SNAplus2 returns the following parameters:
primary_rc
ALLOCATION_ERROR
SNAplus2 could not allocate the APPC conversation with the remote TP.
secondary_rc
47