Command Reference Guide

Administration Commands
query_nmvt_application
information about a specific application or about multiple applications, depending on the options used. For more
information about this MS verb, refer to the HP-UX SNAplus2 MS Programmer’s Guide.
This command must be issued to a running node.
2.151.1 Supplied Parameters
Parameter name Type Length Default
[query_nmvt_application]
num_entries decimal 1
list_options constant LIST_INCLUSIVE
application character 8 (null string)
Supplied parameters are:
num_entries
Maximum number of applications for which data should be returned. You can specify 1 to return data for
a specific application, a number greater than 1 to return data for multiple applications, or 0 (zero) to return
data for all applications.
list_options
The position in the list of applications from which SNAplus2 begins to return data.
Possible values are:
FIRST_IN_LIST
Start at the first entry in the list
LIST_INCLUSIVE
Start at the entry specified by the application parameter
LIST_FROM_NEXT
Start at the entry immediately following the entry specified by the application parameter
application
Application name for which information is required, or the name to be used as an index into the list of
applications. This parameter is ignored if list_options is set to FIRST_IN_LIST. The name is a type-A
character string.
2.151.2 Returned Parameters
Parameter name Type Length
application character 8
ms_vector_key_type decimal
conversion_required constant
If the command executes successfully, SNAplus2 returns the following parameters:
application
Name of the registered application.
ms_vector_key_type
MS vector key accepted by the application. When the application registers for NMVT messages, it specifies
which MS vector keys it accepts. A value of
0xFFFF indicates that the application has registered for all keys.
A value of
0xFFFE indicates that the application has registered for all SPCF keys.
465