Command Reference Guide

Administration Commands
query_nmvt_application
The name of the mode for which information is required, or the name to be used as an index into the list.
This value is ignored if
list_options is set to FIRST_IN_LIST. To return information about the default COS
that is used for any unrecognized mode names, set this parameter to a pair of angle brackets <> (indicating
an empty hexadecimal array).
2.150.2 Returned Parameters
Parameter name Type Length
mode_name character 8
cos_name character 8
If the command executes successfully, SNAplus2 returns the following parameters:
mode_name
Mode name.
cos_name
Class of service name associated with the mode name.
2.150.3 Error Return Codes
If the command cannot be executed, SNAplus2 returns a primary return code to indicate the type of error and a
secondary return code to provide specific details about the reason for unsuccessful execution.
Parameter Check
If the command does not execute because of a parameter error, SNAplus2 returns the following parameters:
primary_rc
PARAMETER_CHECK
secondary_rc
Possible values are:
INVALID_MODE_NAME
The list_options parameter was set to LIST_INCLUSIVE to list all entries starting from the supplied
name, but the mode_name parameter value was not valid.
State Check
No specific state errors, other than those listed in Appendix A, Common Return Codes from snapadmin Commands,
occur for this command.
Other Conditions
Appendix A, Common Return Codes from snapadmin Commands, lists combinations of primary and secondary
return codes that are common to all commands.
2.151 query_nmvt_application
The query_nmvt_application command returns a list of applications that have registered for NMVT-level
messages (by issuing the MS verb REGISTER_NMVT_APPLICATION). This command can be used to obtain
464