Command Reference Guide

Administration Commands
query_ls
NO
Use effect_cap through user_def_parm_3 parameters returned on this command.
ls_attributes
Attributes of the remote system with which SNAplus2 is communicating.
This parameter is usually set to
SNA, unless you are communicating with a host of one of the other types
listed below. Possible values are:
SNA
Standard SNA host.
FNA
Fujitsu Network Architecture (VTAM-F) host.
HNA
Hitachi Network Architecture host.
SUPPRESS_CP_NAME
Suppress the CP name associated with the remote node.
If this LS is to a back-level LEN node that cannot accept the Network Name CV in the format 3 XID it
receives, a
+ character is used to combine the value
SNA,
FNA,orHNA
with SUPPRESS_CP_NAME (for example,
SNA+SUPPRESS_CP_NAME). If the LS is to any other node type, or to a back-level node that can accept the
Network Name CV, the option
SUPPRESS_CP_NAME is not used.
adj_node_id
Node ID of adjacent node. This ID is a 4-byte hexadecimal string; a value of 4 zeros indicates that node ID
checking is disabled.
local_node_id
Node ID sent in XIDs on this LS. This ID is a 4-byte hexadecimal string; a value of 4 zeros indicates that
SNAplus2 uses the node ID specified in define_node.
cp_cp_sess_support
Specifies whether CP-CP sessions are supported. Possible values are:
YES
CP-CP sessions are supported.
NO
CP-CP sessions are not supported.
effect_cap
A decimal value representing the line speed in bits per second.
connect_cost
Cost per connect time.
byte_cost
Cost per byte.
security
Security level of the network. Possible values are:
SEC_NONSECURE
No security.
SEC_PUBLIC_SWITCHED_NETWORK
425