Command Reference Guide

Administration Commands
query_ls
For SDLC, the following parameters are included. For more information about these parameters, see Section 2.51,
define_sdlc_ls.
address hex number
contact_timer decimal
contact_timer_retry decimal
contact_timer2 decimal
contact_timer_retry2 decimal
disc_timer decimal
disc_timer_retry decimal
nve_poll_timer decimal
nve_poll_timer_retry decimal
nve_poll_timer2 decimal
nve_poll_timer_retry2 decimal
no_resp_timer decimal
no_resp_timer_retry decimal
rem_busy_timer decimal
rem_busy_timer_retry decimal
rr_timer decimal
poll_frame constant
poll_on_iframe constant
opt1 constant
linesp decimal
hmod_data character 80
For QLLC, the following parameters are included. For more information about these parameters, see Section 2.45,
define_qllc_ls.
address character 14
vc_type constant
req_rev_charge constant
loc_packet constant
rem_packet constant
loc_wsize decimal
rem_wsize decimal
fac character 32
retry_limit decimal
retry_timeout decimal
idle_timeout decimal
pvc_id decimal
sn_id character 3
cud character 16
For Token Ring, Ethernet, or FDDI, the following parameters are included. For more information about these
parameters, see Section 2.60, define_tr_ls, define_ethernet_ls, define_fddi_ls.
mac_address hex array 6
lsap_address hex number
For Token Ring / Ethernet / FDDI:
test_timeout decimal
test_retry_limit decimal
xid_timeout decimal
xid_retry_limit decimal
t1_timeout decimal
t1_retry_limit decimal
For Enterprise Extender (HPR/IP), the following parameters are included. The parameter determined_ip_address is
described below; for more information about the remaining parameters, see Section 2.32, define_ip_ls.
determined_ip_address character
lsap_address hex number
416