Command Reference Guide

Administration Commands
query_focal_point
num_entries
Maximum number of focal point entries for which data should be returned. You can specify 1 to return data
for a specific focal point, a number greater than 1 to return data for multiple focal points, or 0 (zero) to
return data for all focal points.
list_options
The position in the list of focal points from which SNAplus2 begins to return data.
Possible values are:
FIRST_IN_LIST
Start at the first entry in the list
LIST_INCLUSIVE
Start at the entry specified by the ms_category parameter
LIST_FROM_NEXT
Start at the entry immediately following the entry specified by the ms_category parameter
ms_category
Management Services category. This parameter is not used if list_options is set to FIRST_IN_LIST. This
category may be one that is specified in Systems Network Architecture: Management Services or a user-defined
category. A user-defined category name is a type-1134 character string.
2.132.2 Returned Parameters
Parameter name Type Length
ms_appl_name character 8
ms_category character 8
fp_fqcp_name character 17
description character 31
bkup_appl_name character 8
bkup_fp_fqcp_name character 17
implicit_appl_name character 8
implicit_fp_fqcp_name character 17
fp_type constant
fp_status constant
fp_routing constant
appl_name character 8
If the command executes successfully, SNAplus2 returns the following parameters:
ms_appl_name
Name of the currently active focal point application. This name is one of the MS Discipline-Specific
Application Program names specified in Systems Network Architecture: Management Services, or a user-
defined category name.
ms_category
Management Services category. This category is one of the category names specified in Systems Network
Architecture: Management Services, or a user-defined category name.
fp_fqcp_name
Fully qualified control point name of the focal point.
To revoke the existing focal point for the specified MS category, do not specify this parameter.
388