Command Reference Guide

Administration Commands
query_downstream_pu
The BIND sender is the node containing the secondary link station.
NO
The BIND sender is the node containing the primary link station.
pacing_type
The type of receive pacing in use on the PU-SSCP. This parameter will always be set to
NONE.
2.129.3 Error Return Codes
If the command cannot be executed, SNAplus2 returns a primary return code to indicate the type of error and a
secondary return code to provide specific details about the reason for unsuccessful execution.
Parameter Check
If the command does not execute because of a parameter error, SNAplus2 returns the following parameters:
primary_rc
PARAMETER_CHECK
secondary_rc
Possible values are:
INVALID_PU_NAME
The
list_options parameter was set to LIST_INCLUSIVE to list all entries starting from the supplied
name, but the value specified in the dspu_name parameter was not valid.
State Check
If the command does not execute because of a state error, SNAplus2 returns the following parameters:
primary_rc
STATE_CHECK
secondary_rc
INVALID_PU_TYPE
The PU specified by the dspu_name parameter is not a downstream PU.
Function Not Supported
If the command does not execute because the node’s configuration does not support it, SNAplus2 returns the
following parameters:
primary_rc
FUNCTION_NOT_SUPPORTED
The local node does not support PU concentration or DLUR; support is defined by the pu_conc_support
and dlur_support parameters in the node definition.
secondary_rc
(This parameter is not used.)
Other Conditions
Appendix A, Common Return Codes from snapadmin Commands, lists combinations of primary and secondary
return codes that are common to all commands.
380