Command Reference Guide

Administration Commands
query_dlc_trace
Maximum number of entries for which data should be returned. You can specify 1 to return data for a specific
entry, a number greater than 1 to return data for multiple entries, or 0 (zero) to return data for all entries.
list_options
The position in the list of entries from which SNAplus2 begins to return data. The list is ordered by
resource_type and then by resource_name.
Possible values are:
FIRST_IN_LIST
Start at the first entry in the list
LIST_INCLUSIVE
Start at the entry specified by the resource_type and resource_name parameters
LIST_FROM_NEXT
Start at the entry immediately following the entry specified by the resource_type and resource_name
parameters
list_type
The type of resource for which to list tracing options. Possible values are:
ALL_DLC_TRACES
List all specified tracing options (for any resource type).
ALL_RESOURCES
List the tracing options specified for all resources (defined using add_dlc_trace with a resource
type of ALL_RESOURCES).
DLC
List tracing options for DLC resources.
PORT
List tracing options for port resources for which all link stations are traced.
LS
List tracing options for link station (LS) resources.
RTP
List tracing options for RTP connection resources.
PORT_DEFINED_LS
List tracing options for port resources for which only defined link stations (not implicit link stations)
are traced.
PORT_IMPLICIT_LS
List tracing options for port resources for which only implicit link stations (not defined link stations)
are traced.
resource_type
Specifies the resource type of the entry to be returned, or the entry to be used as an index into the
list. This parameter is used only if list_type is set to ALL_DLC_TRACES and list_options is not set to
FIRST_IN_LIST. Possible values are:
ALL_RESOURCES
352