Command Reference Guide

Administration Commands
query_defaults
Name of the PU associated with the currently active default PU session.
This parameter usually contains the same value as the def_pu_name parameter. However, if a new default
PU has been defined but the session associated with it is not active, SNAplus2 continues to use the session
associated with the previous default PU until the session associated with the defined default PU becomes
active. In this case, def_pu_sess specifies the name of the previous default PU, and is different from the
def_pu_name parameter.
This parameter is blank if there are no active PU sessions.
2.116.3 Error Return Codes
If the command cannot be executed, SNAplus2 returns a primary return code to indicate the type of error and a
secondary return code to provide specific details about the reason for unsuccessful execution.
Parameter Check
No parameter errors occur for this command.
State Check
No specific state errors, other than those listed in Appendix A, Common Return Codes from snapadmin Commands,
occur for this command.
Other Conditions
Appendix A, Common Return Codes from snapadmin Commands, lists combinations of primary and secondary
return codes that are common to all commands.
2.117 query_defaults
The query_defaults command enables the user to query the default parameters defined for the node (default
parameters are defined using define_defaults).
2.117.1 Supplied Parameters
[query_defaults]
No parameters are supplied for this command.
2.117.2 Returned Parameters
Parameter name Type Length
description character 31
mode_name character 8
implicit_plu_forbidden constant
specific_security_sense_codes constant
limited_timeout decimal
If the command executes successfully, the following parameters are returned:
description
A text string describing the default parameters, as specified on the define_defaults command.
mode_name
335