Command Reference Guide

Administration Commands
query_cpic_side_info
Delay is greater than 250 microseconds (typical delay for a satellite link), or maximum propagation
delay. This value is returned if the define_cos specified either PROP_DELAY_SATELLITE or
PROP_DELAY_MAXIMUM for max_prop_delay.
max_user_def_parm_1 through max_user_def_parm_3
Maximum limits for user-defined parameters, which you can use to include TG characteristics not covered
by previously defined parameters. Each of these parameters has a range of
0–255.
weight
Weight associated with this TG row.
2.113.3 Error Return Codes
If the command cannot be executed, SNAplus2 returns a primary return code to indicate the type of error and a
secondary return code to provide specific details about the reason for unsuccessful execution.
Parameter Check
If the command does not execute because of a parameter error, SNAplus2 returns the following parameters:
primary_rc
PARAMETER_CHECK
secondary_rc
Possible values are:
INVALID_COS_NAME
The list_options parameter was set to LIST_INCLUSIVE to list all entries starting from the supplied
name, but the cos_name parameter value was not valid.
State Check
No specific state errors, other than those listed in Appendix A, Common Return Codes from snapadmin Commands,
occur for this command.
Other Conditions
Appendix A, Common Return Codes from snapadmin Commands, lists combinations of primary and secondary
return codes that are common to all commands.
2.114 query_cpic_side_info
The query_cpic_side_info command returns the side information entry for a given symbolic destination
name or for multiple symbolic destination names, depending on the options used.
Because CPI-C side information entries are defined as domain resources, this command is not associated with a
particular node.
2.114.1 Supplied Parameters
Parameter name Type Length Default
[query_cpic_side_info]
num_entries decimal 1
list_options constant LIST_INCLUSIVE
330