Command Reference Guide

Introduction to SNAplus2 Administration Commands

Using snapadmin

You do not need to specify -a to list all resources of a particular type. The -a option is implied by default

if no particular resource is named.

-h

Display help. For more information, see Section 1.1.1, Command Line Options.

-c

Change a particular parameter (available on a select number of define_ commands only). For more

information, see Section 1.1.1, Command Line Options.

-i infile

Use commands from the named ﬁle.

Changing Speciﬁc Parameters

The command line option -c enables the user to change a speciﬁc parameter on an existing command without

reentering the entire command. Specify the command name and parameter to be changed on the command line.

This option is supported only for the following commands (an error message is returned for all other commands):

• define_cpic_side_info

• define_downstream_lu

• define_ethernet_dlc

• define_ethernet_ls

• define_ethernet_port

• define_ip_dlc

• define_ip_ls

• define_ip_port

• define_local_lu

• define_lu_0_to_3

• define_mode

• define_node

• define_partner_lu

• define_qllc_dlc

• define_qllc_ls

• define_qllc_port

• define_rje_wkstn

• define_sdlc_dlc

• define_sdlc_ls

• define_sdlc_port

• define_tp

• define_tr_dlc