Command Reference Guide

Administration Commands
initialize_session_limit
INVALID_NODE_NAME
The node name specified in the configuration file does not match the name of the SNAplus2 computer
to which the command was issued.
NOT_SERVER
The node name specified in the configuration file matches the name of the SNAplus2 computer, but the
specified computer is a client (not a server) and cannot run the node.
DLUR_NOT_SUPPORTED
The configuration of the node specifies that DLUR is supported, but the node is defined as a LEN node.
DLUR cannot be supported on a LEN node.
State Check
If the command does not execute because of a state error, SNAplus2 returns the following parameters:
primary_rc
STATE_CHECK
secondary_rc
Possible values are:
NODE_ALREADY_STARTED
The node name specified in the configuration file has already been started.
RESOURCE_NOT_LOADED
The node was not started because SNAplus2 detected one or more errors while attempting to load its
configuration. Check the error log file for details about the errors.
INVALID_VERSION
The node was not started because there was a version mismatch between components of the SNAplus2
software. If you have upgraded your SNAplus2 license to include additional functions or users, check
that you are using the correct version of the licensing software.
Other Conditions
Appendix A, Common Return Codes from snapadmin Commands, lists combinations of primary and secondary
return codes that are common to all commands.
2.96 initialize_session_limit
The initialize_session_limit command initializes the session limits for a combination of local LU,
partner LU, and mode. This command must be issued to a running node.
You must issue this command before you issue an activate_session command.
2.96.1 Supplied Parameters
Parameter name Type Length Default
[initialize_session_limit]
lu_name character 8 (null string)
lu_alias character 8 (null string)
plu_alias character 8 (null string)
fqplu_name character 17 (null string)
mode_name character 8
289