Command Reference Guide

Administration Commands
init_node
PARAMETER_CHECK
secondary_rc
Possible values are:
NO_PROFILES
The delete_type parameter was set to REMOVE_PROFILES, but no profiles were specified.
UNKNOWN_USER
The user_id parameter did not match a defined user ID.
INVALID_UPDATE_TYPE
The delete_type parameter was set to a value that was not valid.
State Check
No specific state errors, other than those listed in Appendix A, Common Return Codes from snapadmin Commands,
occur for this command.
Other Conditions
Appendix A, Common Return Codes from snapadmin Commands, lists combinations of primary and secondary
return codes that are common to all commands.
2.95 init_node
The init_node command starts the local node. It must be issued to a server where the node is not running. The
SNAplus2 software must be started on the computer containing the node.
2.95.1 Supplied Parameters
[init_node]
No parameters are supplied for this command.
2.95.2 Returned Parameters
No parameters are returned by SNAplus2 when this command executes successfully.
2.95.3 Error Return Codes
If the command cannot be executed, SNAplus2 returns a primary return code to indicate the type of error and a
secondary return code to provide specific details about the reason for unsuccessful execution.
Parameter Check
If the command does not execute because of a parameter error, SNAplus2 returns the following parameters:
primary_rc
PARAMETER_CHECK
secondary_rc
Possible values are:
288