Command Reference Guide

Administration Commands
delete_partner_lu
Parameter Check
If the command does not execute because of a parameter error, SNAplus2 returns the following parameters:
primary_rc
PARAMETER_CHECK
secondary_rc
Possible values are:
CP_OR_SNA_SVCMG_UNDELETABLE
The specified mode name is one of the SNA-defined mode names and cannot be deleted.
MODE_NAME_NOT_DEFD
The specified mode name is not the name of a mode defined on the SNAplus2 system.
DEL_MODE_DEFAULT_SPCD
The specified mode was defined as the default mode using the
define_defaults command, so it
cannot be deleted.
MODE_UNDELETABLE
The specified mode name is one of the SNA-defined mode names and cannot be deleted.
State Check
No specific state errors, other than those listed in Appendix A, Common Return Codes from snapadmin Commands,
occur for this command.
Other Conditions
Appendix A, Common Return Codes from snapadmin Commands, lists combinations of primary and secondary
return codes that are common to all commands.
2.85 delete_partner_lu
The delete_partner_lu command deletes a partner LU definition.
2.85.1 Supplied Parameters
Parameter name Type Length
[delete_partner_lu]
fqplu_name character 17
Supplied parameter is:
fqplu_name
Fully qualified name of the partner LU. Specify 3–17 type-A characters consisting of a 1–8 character network
name, followed by a period, followed by a 1–8 character partner LU name.
2.85.2 Returned Parameters
No parameters are returned by SNAplus2 when this command executes successfully.
277