Command Reference Guide

Administration Commands
define_tr_ls, define_ethernet_ls, define_fddi_ls
Specify a value in the range 1–65,534, or specify 65,535 to indicate that SNAplus2 should retry indefinitely
until it contacts the DLUS.
branch_link_type
This parameter applies only if the local node is a Branch Network Node; it is not used if the local node is
any other type.
If the parameter
adj_cp_type is set to NETWORK_NODE, END_NODE, APPN_NODE,or
BACK_LEVEL_LEN_NODE, this parameter defines whether the link is an uplink or a downlink.
Possible values are:
UPLINK
The link is an uplink.
DOWNLINK
The link is a downlink.
If adj_cp_type is set to NETWORK_NODE, this parameter must be set to UPLINK.
adj_brnn_cp_support
This parameter applies only if the local node is a Branch Network Node and the adjacent node is a network
node (the parameter adj_cp_type is set to NETWORK_NODE, or it is set to APPN_NODE and the node type
discovered during XID exchange is network node). It is not used if the local and remote nodes are any other
type.
This parameter defines whether the adjacent node can be a Branch Network Node that is acting as a Network
Node from the point of view of the local node. Possible values are:
ALLOWED
The adjacent node is allowed (but not required) to be a Branch Network Node.
REQUIRED
The adjacent node must be a Branch Network Node.
PROHIBITED
The adjacent node must not be a Branch Network Node.
If adj_cp_type is set to NETWORK_NODE and auto_act_supp is set to YES, this parameter must be set to
REQUIRED or PROHIBITED.
initially_active
Specifies whether this LS is automatically started when the node is started. Possible values are:
YES
The LS is automatically started when the node is started.
NO
The LS is not automatically started; it must be manually started.
react_timer
Reactivation timer for reactivating a failed LS. If the react_timer_retry parameter is a nonzero value (to specify
that SNAplus2 should retry activating the LS if it fails), this parameter specifies the time in seconds between
retries. When the LS fails, or when an attempt to reactivate it fails, SNAplus2 waits for the specified time
before retrying the activation. If react_timer_retry is 0 (zero), this parameter is ignored.
react_timer_retry
235