Command Reference Guide

Administration Commands
define_sdlc_port
Primary
LS_SEC
Secondary
LS_NEG
Negotiable
act_xid_exchange_limit
Activation XID exchange limit. Specify a value in the range 1–65,535.
nonact_xid_exchange_limit
Nonactivation XID exchange limit. Specify a value in the range 1–65,535.
ls_xmit_rcv_cap
Specifies the link station transmit/receive capability. Possible values are:
LS_TWS
Two-way simultaneous
LS_TWA
Two-way alternating
max_ifrm_rcvd
Maximum number of I-frames that can be received by the local link stations before an acknowledgment is
sent. Specify a value in the range 1–127.
target_pacing_count
Indicates the desired pacing window size. Specify a value in the range 1–32,767.
max_send_btu_size
Maximum BTU size that can be sent from this port. This value is used to negotiate the maximum BTU size
that a pair of link stations can use to communicate with each other. The value includes the length of the TH
and RH (total 9 bytes), as well as the RU. Specify a value in the range 265–4105.
address
Port address used for incoming calls.
The value of this parameter depends on how the port that owns this LS is configured, as follows:
• If the port is used only for incoming calls, or if
ls_role is set to LS_PRI,orifls_role is set to LS_NEG
and the local station becomes primary after LS role negotiation, this parameter is reserved.
• If ls_role is set to LS_SEC,orifls_role is set to LS_NEG and the local station becomes secondary after
LS role negotiation, this address is used in the response to an incoming call.
If the address of the remote station is unknown, set this parameter to zero.
implicit_cp_cp_sess_support
Specifies whether CP-CP sessions are allowed for implicit link stations using this port. Possible values are:
YES
CP-CP sessions are allowed for implicit link stations.
NO
CP-CP sessions are not allowed for implicit link stations.
202