Command Reference Guide

Administration Commands
define_rcf_access
If the address does not match, an LS is dynamically defined. To ensure that the explicit LS definition (including
the required PU name) is used, be sure that the address defined for this LS matches the address that is supplied by
the host or the downstream computer on the incoming call.
2.47 define_rcf_access
The define_rcf_access command defines access to the SNAplus2 Remote Command Facility (RCF). This
command defines the user ID used to run UNIX Command Facility (UCF) commands and the restrictions under which
administration commands can be issued using the Service Point Command Facility (SPCF). For more information
about SPCF and UCF, refer to the HP-UX SNAplus2 Administration Guide. You can use this command to permit
access to SPCF, UCF, or both.
The command can be used to specify the RCF access for the first time, or to modify an existing definition. Because
RCF access parameters are defined as domain resources, this command is not associated with a particular node.
SNAplus2 acts on these parameters during node start-up; if these parameters are changed while a node is running,
the changes do not take effect on the server where the node is running until the node is stopped and restarted.
2.47.1 Supplied Parameters
Parameter name Type Length Default
[define_rcf_access]
ucf_username character 31 (null string)
spcf_permissions constant NONE
Supplied parameters are:
ucf_username
Specifies the HP-UX user name of the UCF user. This parameter is a string of locally displayable characters.
Do not specify the name root; SNAplus2 does not allow UCF commands to be run as root for security rea-
sons.
All UCF commands are run using the user ID for this user, with the default shell, default group ID, and
access permissions that are defined on the HP-UX system for this user.
To prevent access to UCF, do not specify this parameter.
spcf_permissions
Specifies the types of SNAplus2 administration commands that can be accessed using SPCF. To prevent
access to SPCF, set this parameter to NONE. To allow access to SPCF, set this parameter to one or more of
the following values (combined using a + character):
ALLOW_QUERY_LOCAL
The query_* commands are allowed.
ALLOW_DEFINE_LOCAL
The define_*, set_*, delete_*, add_*, remove_* , and init_node commands are allowed.
ALLOW_ACTION_LOCAL
The start_*, stop_*, activate_*, deactivate_*, aping, initial-
ize_session_limit, change_session_limit, and reset_session_limit
commands are allowed.
ALLOW_QUERY_REMOTE
174