Command Reference Guide

Administration Commands
define_qllc_ls
A decimal value representing the line speed in bits per second.
connect_cost
Cost per connect time. Valid values are integer values in the range 0–255, where 0 is the lowest cost per
connect time and 255 is the highest cost per connect time.
byte_cost
Cost per byte. Valid values are integer values in the range 0–255, where 0 is the lowest cost per byte and
255 is the highest cost per byte.
security
Security level of the network. Possible values are:
SEC_NONSECURE
No security.
SEC_PUBLIC_SWITCHED_NETWORK
Data is transmitted over a public switched network.
SEC_UNDERGROUND_CABLE
Data is transmitted over secure underground cable.
SEC_SECURE_CONDUIT
Data is transmitted over a line in a secure conduit that is not guarded.
SEC_GUARDED_CONDUIT
Data is transmitted over a line in a conduit that is protected against physical tapping.
SEC_ENCRYPTED
Data is encrypted before transmission over the line.
SEC_GUARDED_RADIATION
Data is transmitted over a line that is protected against physical and radiation tapping.
prop_delay
Propagation delay (the time that a signal takes to travel the length of the link). Specify one of the following
values, according to the type of link:
PROP_DELAY_MINIMUM
Minimum propagation delay.
PROP_DELAY_LAN
Delay is less than .5 microseconds (typical for a LAN).
PROP_DELAY_TELEPHONE
Delay is in the range .5–50 microseconds (typical for a telephone network).
PROP_DELAY_PKT_SWITCHED_NET
Delay is in the range 50–250 microseconds (typical for a packet-switched network).
PROP_DELAY_SATELLITE
Delay is greater than 250 microseconds (typical for a satellite link).
PROP_DELAY_MAXIMUM
158