Command Reference Guide

Administration Commands
define_qllc_ls
SNA
Standard SNA host.
FNA
Fujitsu Network Architecture (VTAM-F) host
HNA
Hitachi Network Architecture host
SUPPRESS_CP_NAME
Suppress the CP name associated with the remote node. Use a + character to combine this value with
SNA, FNA,orHNA.
If adj_cp_type is set to BACK_LEVEL_LEN_NODE, and the remote LEN node associated with this LS cannot
accept the Network Name CV in the format 3 XID it receives, use a + character to combine the value SNA,
FNA,orHNA with SUPPRESS_CP_NAME (for example, SNA+SUPPRESS_CP_NAME).
If adj_cp_type is set to any other value, the SUPPRESS_CP_NAME option is ignored.
adj_node_id
Node ID of adjacent node. This ID is a 4-byte hexadecimal string, consisting of a block number (three
hexadecimal digits) and a node number (five hexadecimal digits). To disable node ID checking, do not
specify this parameter.
local_node_id
Node ID sent in XIDs on this LS. This ID is a 4-byte hexadecimal string, consisting of a block number
(three hexadecimal digits) and a node number (five hexadecimal digits). To use the node ID specified in
define_node, do not specify this parameter.
cp_cp_sess_support
Specifies whether CP-CP sessions are supported. This parameter is valid only if the adjacent node is an end
node or a network node (adj_cp_type is NETWORK_NODE, END_NODE,orLEARN_NODE); it is ignored oth-
erwise. If both the local node and the adjacent node are network nodes, this parameter should be set to YES
in order to use APPN functions between these nodes.
Possible values are:
YES
CP-CP sessions are supported. The solicit_sscp_sessions parameter must be set to NO.
NO
CP-CP sessions are not supported.
use_default_tg_chars
Specifies whether to use the default TG characteristics supplied on define_qllc_port. The TG
characteristics apply only if the link is to an APPN node; this parameter, and effect_cap through
user_def_parm_3 parameters are ignored otherwise. Possible values are:
YES
Use the default TG characteristics; ignore effect_cap through user_def_parm_3 parameters on this
command.
NO
Use effect_cap through user_def_parm_3 parameters on this command.
effect_cap
157