Command Reference Guide

Administration Commands
define_qllc_ls
bkup_dlus_name
Name of the backup DLUS node from which DLUR solicits SSCP services if the node specified by dlus_name
is not active. This parameter is reserved if dspu_services is not set to DLUR.
Specify 3–17 type-A characters that consist of a 1–8 character network name, followed by a period, followed
by a 1–8 character backup LU name.
To specify the global backup default DLUS, defined using define_dlur_defaults, do not specify this
parameter.
hpr_supported
Specifies whether HPR is supported on this link. This parameter must be set to NO unless the adj_cp_type
parameter indicates that the link connects to an APPN node. Possible values are:
YES
HPR is supported on this link.
NO
HPR is not supported on this link.
link_deact_timer
Limited resource link deactivation timer, in seconds. A limited resource link is automatically deactivated if no
data flows over the link for the time specified by this parameter. This parameter is not used if limited_resource
is set to any value other than INACTIVITY.
The minimum value is 5; values in the range 1–4 will be interpreted as 5.
The value 0 (zero) indicates one of the following:
• If the hpr_supported parameter is set to YES, the default deactivation timer value of 30 is used.
• If the hpr_supported parameter is set to NO, no timeout is used (the link is not deactivated, as if lim-
ited_resource were set to NO).
default_nn_server
For an end node this parameter specifies whether the link handled by this link station is a link supporting
CP-CP sessions to a network node that can act as the local node’s network node server. When the local
node has no CP-CP sessions to a network node server and needs to establish them, the local node checks
this parameter on its defined link stations to find a suitable LS to activate. This enables you to specify which
adjacent NNs are suitable to act as the NN server (for example, to avoid using NNs that are accessed by
expensive or slow links).
Possible values are:
YES
This link supports CP-CP sessions to a network node that can act as the local node’s NN server; the local
node can automatically activate this link if it needs to contact an NN server. The cp_cp_sess_support
parameter must be set to YES.
NO
This link should not be automatically activated when an attempt is made to contact an NN server.
If the local node is not an end node, this parameter is ignored. If the local node is not an end node, this
parameter is ignored.
ls_attributes
Attributes of the remote system with which SNAplus2 is communicating.
Specify SNA unless you are communicating with a host of another type. Possible values are:
156