Command Reference Guide

Administration Commands
define_node
End Node: DLUR is supported, but will not be used to connect to a DLUS in another subnet. If
multi-subnet operation is not required, you should use this value instead of YES, to reduce network
traffic and congestion at the network node.
This value is not supported for a Network Node.
NO
DLUR is not supported.
pu_conc_support
Specifies whether PU concentration is supported. Possible values are:
YES
PU concentration is supported.
NO
PU concentration is not supported.
nn_rar
The network node’s route additional resistance. This value is used in APPN route calculations to determine if
the node is useful as an intermediate hop. A high value indicates that this node is not useful as an intermediate
hop. Values must be in the range
0–255.
max_ls_exception_events
The maximum number of LS exception events to be recorded by the node.
max_compression_level
The maximum compression supported by the node for LU session data. This parameter must be set to LZ10
(the default); do not attempt to set any value other than the default.
ptf_flags
Options for configuring and controlling program temporary fix (ptf) operation. Set this parameter to NONE
if none of the options described are required, or to one or more of the values described as follows. If two or
more values are required, combine them with a + character.
Available options are:
NONE
None of the options described following are required.
OVERRIDE_ERP
SNAplus2 normally processes an ACTPU(ERP) as an ERP; this resets the PU-SSCP session but does
not implicitly deactivate the subservient LU-SSCP and PLU-SLU sessions. SNA implementations may
legally process ACTPU(ERP) as if it were ACTPU(cold), implicitly deactivating the subservient LU-
SSCP and PLU-SLU sessions. To override the default processing and process all ACTPU requests as
ACTPU(cold), use the value OVERRIDE_ERP.
SUPPRESS_BIS
SNAplus2 normally uses the BIS protocol prior to deactivating a limited resource LU 6.2 session. To
suppress use of the BIS protocol so that limited resource LU 6.2 sessions are deactivated immediately
using UNBIND(cleanup), use the value SUPPRESS_BIS.
OVERRIDE_REQDISCONT
SNAplus2 normally uses REQDISCONT to deactivate limited resource host links that are no longer
required by session traffic.
144