Command Reference Guide

Administration Commands
define_lu_0_to_3_range
priority
LU priority when sending to the host. Possible values are:
NETWORK
The LU has priority on the network.
HIGH
High priority is given to the LU.
MEDIUM
Medium priority is given to the LU.
LOW
Low priority is given to the LU.
lu_model
Type of the LU. Possible values are:
3270_DISPLAY_MODEL_2
LU type is a 3270 display model 2.
3270_DISPLAY_MODEL_3
LU type is a 3270 display model 3.
3270_DISPLAY_MODEL_4
LU type is a 3270 display model 4.
3270_DISPLAY_MODEL_5
LU type is a 3270 display model 5.
PRINTER
LU type is a printer.
SCS_PRINTER
LU type is an SCS printer.
RJE_WKSTN
LU type is an RJE workstation.
UNKNOWN
LU type is unknown. (LU type will be determined when the session to the host is established.)
If you are not using the LUs for 3270 emulation or RJE, it is not necessary to specify an explicit LU type;
set this parameter to UNKNOWN.
If the host system supports Dynamic Definition of Dependent LUs (DDDLUs) and this parameter is set to any
value other than UNKNOWN, SNAplus2 will define the LU dynamically on the host when the communications
link to the host is established. If the host does not support DDDLU or if this parameter is set to UNKNOWN,
the LU must be included in the host configuration.
sscp_id
Specifies the ID of the SSCP permitted to activate this LU. Specify a value in the range 0–65,535. If this
parameter is set to 0 (zero), the LU can be activated by any SSCP.
timeout
127