Command Reference Guide

Administration Commands
define_local_lu
If the node that owns this LU is running the newer version of SNAplus2 but the target system is
running the older version, then the target computer is a back-level computer. When you upgrade the
target system later, change this parameter back to
NO.
NO
If both the node that owns this LU and the target system are running the same version of SNAplus2
then the target computer is not a back-level computer.
2.34.2 Returned Parameters
No parameters are returned by SNAplus2 when this command executes successfully.
2.34.3 Error Return Codes
If the command cannot be executed, SNAplus2 returns a primary return code to indicate the type of error and a
secondary return code to provide specific details about the reason for unsuccessful execution.
Parameter Check
If the command does not execute because of a parameter error, SNAplus2 returns the following parameters:
primary_rc
PARAMETER_CHECK
secondary_rc
Possible values are:
INVALID_DISABLE
The disable parameter was not set to a valid value.
INVALID_LU_NAME
The lu_name parameter contained a character that was not valid.
INVALID_NAU_ADDRESS
The nau_address parameter was not in the valid range.
INVALID_SESSION_LIMIT
The lu_session_limit parameter was not in the valid range.
INVALID_TIMEOUT
The timeout parameter was not in the valid range.
State Check
If the command does not execute because of a state error, SNAplus2 returns the following parameters:
primary_rc
STATE_CHECK
secondary_rc
Possible values are:
INVALID_LU_NAME
The lu_name parameter contained a character that was not valid.
LU_ALREADY_DEFINED
An LU with this name has already been defined. You cannot use this command to modify any parameters
of an existing LU except for the Attach routing data.
119