CLI Reference Guide

2-26
NET.CFG Options Reference
Desktop SNMP Option
NOTE: Always place the vlm=mib2if.vlm line after the lines that load the Desktop SNMP
VLM suite of files.
TCP/IP Groups
Desktop SNMP also provides a separate VLM file, MIB2PROT.VLM, that
supports the TCP/IP groups (all groups except interface, system, and SNMP,
which are supported by other VLM files, and EGP and transmission, which
are not supported).
Load this VLM when you are using the TCP/IP stack from LAN
WorkPlace® software.
Add the following lines to the NET.CFG file:
netware dos requester
vlm=mib2prot.vlm
NOTE: Always place the vlm=mib2prot.vlm line after the lines that load the Desktop SNMP
VLM suite of files.
Example of NET.CFG File Including Each Group Support
On a workstation where the NetWare DOS Requester™ and comprehensive
MIB-II support are both loaded, the entire Netware DOS Requester and
Desktop SNMP sections of your NET.CFG file might read as follows:
netware dos requester
vlm=wssnmp.vlm
vlm=wstrap.vlm
vlm=wsreg.vlm
vlm=wsasn1.vlm
vlm=mib2if.vlm
vlm=mib2prot.vlm
desktop snmp
sysname “Suzanne Morley x893”
syslocation “Building 2”
syscontact “[e-mail]”
snmpenableauthentraps on