CLI Reference Guide

2-22
NET.CFG Options Reference
Desktop SNMP Option
desktop snmp
enable monitor community any
monitor community “private”
enable control community specified
control community “private”
enable trap community specified
trap community “agenttrap”
Desktop SNMP ignores the monitor community “private” line until you
reset the enable monitor community line to “specified.” This allows you to
temporarily change the value to “any” or “off” without deleting the specific
community name.
MIB-II (Management Information Base) Support
Desktop SNMP automatically supports three MIB-II groups:
• System and SNMP groups
• Interface group
• TCP/IP groups (all groups except interface, system, and SNMP, which are
supported by other VLM™ files, and EGP and transmission, which are not
supported)
System and SNMP Groups
Use these parameters and values to define information that can be retrieved
by SNMP management stations or reported in SNMP traps, which are
discussed on the indicated pages:
Desktop SNMP automatically supports two MIB-II groups, system and
SNMP. These groups provide SNMP management stations with information
about your workstation and about Desktop SNMP.
Parameters and Values
SNMPENABLEAUTHENTRAP [on | off]
SYSCONTACT “contact”
SYSLOCATION “location”
SYSNAME “name”