CLI Reference Guide

4-38

System Messages

Explanation: The VLM™ programs for the NetWare® DOS Requester™

software have been improperly conﬁgured to include two programs with the

same VLM ID. This can be caused by either a VLM being included twice in

the VLM= parameter list, or by a VLM attempting to reuse a VLM ID

assigned to a different VLM.

Action: Check the NET.CFG ﬁle for duplicates in the VLM list. Make sure

that the USE DEFAULTS= parameter is set to OFF. See Chapter 2,

“NET.CFG Options Reference,” for more information.

VLM-1.00-47: A ﬁle server could not be found. Check the network

cabling and the server’s status before continuing.

Explanation: No NetWare® server was found when attempting to build an

initial connection. This could be caused by any of the following:

• An improperly configured network board or LAN driver

• Improperly configured IPX™ software

• A disconnected network cable

• An attempt to load the NetWare DOS Requester™ software before a NetWare

server has been initialized.

Try one or more of the following:

• Ensure that the network board and LAN driver are properly configured by

checking the network board settings and the NET.CFG file settings.

See Chapter 2, “NET.CFG Options Reference,” for more information.

• Ensure that IPX is configured to be bound properly to the right LAN driver.

• Check the network cabling.

• Ensure that a NetWare server is up and running before attempting to load the

NetWare DOS Requester.

VLM-1.00-60: There is an unrecognized entry ‘<entry>’ on line

<number> of the conﬁguration ﬁle. This entry will be ignored. Correct

the line speciﬁed in the conﬁguration ﬁle before continuing.

Explanation: The conﬁguration ﬁle contains a parameter under a header

where it does not belong. This invalid line is ignored by the conﬁguration

process.