Manualshelf

CLI Reference Guide

ManualsBrandsHP ManualsSoftwareHP HP-UX Internet and Networking Software
201202203204205206207208209210
4-37
System Messages
Action: No action is required at this point. However, to avoid this message
the next time the VLM.EXE file is loaded, delete or correct the line specified
by the error message.
VLM-1.00-43: There is a missing or invalid ON/OFF value for
‘<parameter>’ on line <number> of the configuration file. This entry
will be ignored. Correct the line specified in the configuration file before
continuing.
Explanation: The configuration file contains a parameter that is defined to
use either an ON or OFF value, but a different value or no value has been
specified. This invalid line is ignored by the configuration process.
Action: No action is required at this point. However, to avoid this message
the next time the VLM.EXE file is loaded, delete or correct the line specified
by the error message.
VLM-1.00-44: There is an invalid string length specified for
‘<parameter>’ on line <number> of the configuration file. This entry
will be ignored. Correct the line specified in the configuration file before
continuing.
Explanation: The configuration file contains a parameter that is defined to
use a string of a specified minimum or maximum length, but a string has
been entered that does not fit the specified limits. This invalid line is ignored
by the configuration process.
Action: No action is required at this point. However, to avoid this message
the next time the VLM.EXE file is loaded, delete or correct the line specified
by the error message.
VLM-1.00-45: The parameter specified for the following option was out
of range and has been adjusted.
Explanation: A configurable parameter has been configured too high or too
low to be valid. The parameter is specified on the line following the
message.
Action: Check and correct the parameter specified in the NET.CFG file. See
Chapter 2, “NET.CFG Options Reference,” for more information.
VLM-1.00-46: A duplicate VLM ID was found during VLM load test.
The file will not be loaded. check the VLM= and USE DEFAULTS=
parameters specified in the NET.CFG file before continuing.