CLI Reference Guide

4-34
System Messages
Explanation: The NetWare® DOS Requester™ software cannot function
properly when loaded after a task switcher. A task switcher has been
previously loaded. (Task switchers include DR DOS® TaskMax, MS-DOS*
5.0 DOSSHELL, and MS Windows 3.1 in standard mode.)
Action: Unload the task switcher before attempting to load the NetWare
DOS Requester.
VLM-1.00-31: Network error on server <name>. Check network
cabling or server status.
Explanation: This is a critical communications error between the client
workstation and the NetWare® server. This error may also appear as
“General failure on device NETWORK.” A communications error can be
caused by either a hardware or software failure.
Action: Check the hardware and make sure that the network cable is
connected properly and that the NetWare server is up and running properly.
If the condition persists, report the problem to your Novell Authorized
ResellerCLM representative.
VLM-1.00-32: The VLM.EXE file is not loaded. VLM.EXE cannot be
unloaded.
Explanation: An attempt was made to unload the VLM.EXE file using the /
U parameter.
Action: The condition that caused this message to occur is invalid, so no
action is required.
VLM-1.00-33: The loaded VLM.EXE file has a different version.
VLM.EXE cannot be unloaded. Make sure the VLM.EXE file you are
using has the same version number and then try to unload VLM.EXE.
Explanation: An attempt was made to unload the VLM.EXE file using the /
U parameter.
Action: Use the same version of the VLM.EXE file to try the unload as was
used to load; otherwise, the VLM.EXE file that is loaded in memory can be
removed only by rebooting the computer.