CLI Reference Guide

4-32
System Messages
Action: Either update the .MSG file with a valid copy or delete the file. The
NetWare® DOS Requester™ software uses the default messages that are
bound to the binary files.
VLM-1.00-8: The VLM.EXE file is already loaded. VLM.EXE cannot
be reloaded. If you want to load VLM.EXE with a different
configuration, unload VLM.EXE first with the /U parameter and then
try loading the VLM.EXE file.
Explanation: The VLM.EXE file has already been loaded into memory.
There cannot be two copies of the VLM.EXE file loaded in memory at one
time.
Action: If the VLM.EXE file is being reloaded in an attempt to reconfigure
the VLM™ program already loaded, you must first unload VLM.EXE using
the /U parameter; then reload VLM.EXE.
VLM-1.00-9: The VLM.EXE file is testing the VLMs.
Explanation: This message is used to show the progress the VLM.EXE file
is making in configuring the VLM™ programs to be loaded. Because this
process can take a few seconds, the progress is displayed using a period (.) to
indicate each VLM being tested.
Action: No action is required; this is simply an information message.
VLM-1.00-10: The conventional memory block for the EMS stack
cannot be resized. The VLM.EXE file cannot be loaded. DOS memory is
probably corrupt. Reboot your computer and then try to load the
VLM.EXE again.
Explanation: This error indicates that the DOS memory chain has been
corrupted.
Action: It is unsafe to continue operating the computer. The best solution is
to reboot the computer; then try to load the VLM.EXE file.
VLM-1.00-11: There is insufficient memory to load the VLMs. The
VLM.EXE file cannot be loaded. Reconfigure the VLMs to be loaded in
the NET.CFG file and then try to load the VLM.EXE file.