CLI Reference Guide

4-29
System Messages
SECURITY-1.00-42: There is a missing or invalid value for
‘<parameter>’ on line <number> of the configuration file. This entry
will be ignored. Correct the line specified in the configuration file before
continuing.
Explanation: The configuration file contains a parameter that has an invalid
value or that does not specify a value. This invalid line is ignored by the
configuration process.
Action: No action is required at this point. However, to avoid this message
the next time the VLM.EXE file is loaded, delete or correct the line specified
by the error message.
SECURITY-1.00-43: There is a missing or invalid ON/OFF value for
‘<parameter>’ on line <number> of the configuration file. This entry
will be ignored. Correct the line specified in the configuration file before
continuing.
Explanation: The configuration file contains a parameter that is defined to
use either an ON or OFF value, but a different value or no value has been
specified. This invalid line is ignored by the configuration process.
Action: No action is required at this point. However, to avoid this message
the next time VLM.EXE is loaded, delete or correct the line specified by the
error message.
SECURITY-1.00-45: The parameter specified for the following option
was out of range and has been adjusted.
Explanation: A configurable parameter has been configured too high or too
low to be valid. The parameter is specified on the line following the
message.
Action: Check and correct the parameter specified in the NET.CFG file. See
Chapter 2, “NET.CFG Options Reference,” for more information.
SECURITY-1.00-67: The SECURITY.VLM file must be loaded before
any other NetWare Protocol Module. The SECURITY.VLM file will not
be loaded. Load the SECURITY.VLM file before loading any NetWare
Protocol Modules.