CLI Reference Guide

4-20
System Messages
Explanation: A configurable parameter has been configured too high or too
low to be valid. The parameter is specified on the line following the
message.
Action: Check and correct the parameter specified in the NET.CFG file. See
Chapter 2, “NET.CFG Options Reference,” for more information.
NETX-1.00-57: DOS is only configured for <number> drives,
NETX.VLM requires 26 drives for full functionality. The NETX.VLM
file will load with partial support. Add LASTDRIVE=Z to the
CONFIG.SYS file and reboot the workstation; then load the
NETX.VLM file.
Explanation: This message is only a warning. However, if you want full
compatibility with the NetWare® shell, you must set the DOS LASTDRIVE
parameter in the CONFIG.SYS file to Z. Otherwise, problems occur when
mapping drives, etc.
Action: Set LASTDRIVE=Z in the CONFIG.SYS file; then reboot the client
workstation before loading the NetWare DOS Requester™ software.
NETX-1.00-58: The PRINT.VLM file has not been loaded. The
NETX.VLM file will load successfully without print services. To enable
printing services, load the PRINT.VLM file before loading the
NETX.VLM file.
Explanation: This message is only a warning. For full NetWare® shell
compatibility, the PRINT.VLM file must be loaded.
Action: If you want print functionality, load the PRINT.VLM file before
loading the NETX.VLM file.
NMR-1.00-1: The message file <name> is invalid. The program cannot
be loaded.
Explanation: The .MSG file is invalid. This problem could be the result of a
corrupted file, a bad translation, or an outdated file version.
Action: Either update the .MSG file with a valid copy or delete the file. The
NetWare® DOS Requester™ software uses the default messages that are
bound to the binary files.