CLI Reference Guide

4-17
System Messages
Explanation: The .MSG file is invalid. This problem could be the result of a
corrupted file, a bad translation, or an outdated file version.
Action: Either update the .MSG file with a valid copy or delete the file. The
NetWare® DOS Requester™ software uses the default messages that are
bound to the binary files.
NDS-1.00-5: <Module1>.VLM is not loaded. The <module2>.VLM file
cannot be loaded before <module1>.VLM. Load the <module1>.VLM
file first then try to load the <module2>.VLM file.
Explanation: The <module2>.VLM file requires that the <module1>.VLM
file be loaded first. Either the current configuration has <module1>.VLM
and <module2>.VLM loading out of order, or <module1>.VLM did not load
successfully.
Action: Make sure that <module1>.VLM is configured to load before
<module2>.VLM. To do this, change the load order of the VLM= parameter
in the NET.CFG file.
NDS-1.00-7: In order to load the <module3>.VLM, one of the following
VLMs must be loaded: <module1>.VLM, <module2>.VLM.
Explanation: The <module3>.VLM file requires that the <module1>.VLM
or <module2>.VLM file be loaded first. Either the current configuration has
<module3>.VLM loading before <module1>.VLM or <module2>.VLM, or
<module1>.VLM or <module2>.VLM did not load successfully.
Action: Make sure that <module1>.VLM or <module2>.VLM loads
successfully before <module3>.VLM.
NDS-1.00-42: There is a missing or invalid value for ‘<parameter>’ on
line <number> of the configuration file. This entry will be ignored.
Correct the line specified in the configuration file before continuing.
Explanation: The configuration file contains a parameter that has an invalid
value or that does not specify a value. This invalid line is ignored by the
configuration process.
Action: No action is required at this point. However, to avoid this message
the next time the VLM.EXE file is loaded, delete or correct the line specified
by the error message.