CLI Reference Guide

4-15
System Messages
Explanation: The configuration file contains a parameter that is defined to
use either an ON or OFF value, but a different value or no value has been
specified. This invalid line is ignored by the configuration process.
Action: No action is required at this point. However, to avoid this message
the next time the VLM.EXE file is loaded, delete or correct the line specified
by the error message.
IPXNCP-1.00-45: The parameter specified for the following option was
out of range and has been adjusted.
Explanation: A configurable parameter has been configured too high or too
low to be valid. The parameter is specified on the line following the
message.
Action: Check and correct the parameter specified in the NET.CFG file. See
Chapter 2, “NET.CFG Options Reference,” for more information.
IPXNCP-1.00-53: The IPX interface is not loaded. The IPXNCP.VLM
file cannot be loaded. Load the IPXODI.COM file first and then try
loading the IPXNCP.VLM file.
Explanation: An attempt was made to load the IPXNCP.VLM file without
having previously loaded the IPX™ interface.
Action: Load the IPXODI.COM file before attempting to load
IPXNCP.VLM.
IPXNCP-1.00-54: The IPX sockets could not be opened. The
IPXNCP.VLM file cannot be loaded. Configure the IPXODI.COM file
for enough sockets in the NET.CFG file and then try to load the
IPXNCP.VLM file.
Explanation: The IPXNCP.VLM file failed to open the IPX™ sockets
needed in order to run. The IPXNCP.VLM file requires that four or more
IPX sockets be available to run.
Action: Increase the number of IPX sockets available by using the
IPX SOCKETS= parameter in the NET.CFG file; then reload the
IPXODI.COM and IPXNCP.VLM files.